WP-15 Post Weld Purging -Why is it necessary

38W-QuickPurgePipeWeldPurgeSystemWhilst most welders recognise the need for inert gas purging when making quality joints, it is not obvious why purging should be continued after the weld has been completed. 

The answers are clear:

  1. Hot metal oxidises in the presence of air so the weld and any metal surrounding it will discolour until it has cooled below the oxidation temperature for the metal being welded. This applies equally to the top and bottom weld bead.

  2. Although nominal oxidation, i.e. a light straw shade, is quite acceptable in some cases, and in any event can perhaps be cleaned at a later stage, some applications require total absence from contamination of this type. This is particularly so in the pharmaceutical and semiconductor industries where installations are normally completed in the 'as welded' condition.

The solution is:

  • Continue the flow of inert purge gas over the hot metal until it has cooled—typically to below 150ºC (300ºF).
  • On the subject of purging, let’s have a closer look at purging practice and dispel a few myths that seem to abound. Choosing gas inlet and exit points.

Sealing the pipe

Having recognised the need to use gas purging, many welders think that just passing inert gas through a pipe or tube is adequate. This is poor practice. Even with small diameter tubes, the cost of continuously passing gas through is often greater than the cost of effective seals. Increasing flow rate simply leads to turbulence, trapping air around the joint.

It’s a fallacy that using crumpled paper or discs of cardboard or wood gives a good seal. Even if these apparent solutions appear to be a good fit, the chances of leaks are high. There is also the possibility of burning if the weld line is too close. Bear in mind also that all three materials probably contain contamination and some residual moisture. It’s all bad for the welding procedure.

Proprietary sheet plastics have been developed which are contaminant free and can even be used when making joints for use for example in nuclear and pharmaceutical engineering. These are water soluble and can be removed effectively and easily after welding but care is needed during application. See Huntingdon Fusion Techniques’ Technical Note TN 14 ‘Purge Film’.

Use a commercial purge product

Huntingdon Fusion Techniques HFT® manufactures a unique re-usable range of purging equipment to meet every tube and pipe diameter from 25 to 2440 mm (1 to 96 inch). They have all been designed specifically to meet exacting sealing demands, use the minimum quantity of inert gas, are easy to install and remove and greatly speed up the overall welding procedure. See Technical Notes TN 8 to TN 13.

01W-QuickPurgePipeWeldPurgeSystem29W-PurgEliteWeldPurgeSystems

 

  

Examples of the extensive range is shown here.


These are the worldbeating QuickPurge® II and PurgElite® Inflatable Pipe Weld Purge Systems

 

 

 

Always remember, it’s more cost - effective to use a good purging technique than to resort to post weld grinding and cleaning to compensate for bad practice.

Post Weld Purging -Why is it necessary (Ref WP15)

For further details and information, Cette adresse e-mail est protégée contre les robots spammeurs. Vous devez activer le JavaScript pour la visualiser.

You are not allowed to use or copy any of this material or content without the written permission of Huntingdon Fusion Techniques HFT®, copyright protected. All rights belong to Huntingdon Fusion Techniques HFT® exclusively. Not for any reproduction without consent.