News

Introducing PurgeNet™ and Accessories

visual alarm, purge alarm, purgenet, huntingdon fusion, weld purgingMonitoring the oxygen level before, during and after welding is essential. Welding in an environment of less then 100 ppm for stainless steel and less than 20 ppm for titanium ensures that welds are free from oxidation.

Allowing joints to oxidise when welding then involves mechanical or chemical oxide removal to prevent to loss of corrosion resistance at best and metallurgical imperfections at worst. Oxidation can be prevented by using a Weld Purge Monitor® to verify purge quality prior to the commencement of welding.

Now, Weld Purge Monitors® are available with PurgeNet™, a networking device which is manufactured as standard to five of the PurgEye® Monitors manufactured by Weld Purging Experts Huntingdon Fusion Techniques HFT®.

PurgeNet™ is used for communicating the current oxygen reading from a PurgEye® Weld Purge Monitor® to another piece of equipment, such as the visual warning accessory PurgeAlarm™ or a Dew Point Monitor with additional inter-pass temperature monitoring. 

Ron Sewell, Chairman for HFT® said: “PurgeNet™ adds a new dimension to weld purge monitoring by allowing a range of accessories to simply plug into the PurgEye® Weld Purge Monitors® for automatic control functions based upon oxygen level, dew point and weld substrate temperature.” 

purgeye, weld purge monitor, visual purge alarm, weld purging, huntingdon fusion“For control of Automatic Welding Equipment by a Weld Purge Monitor®, the relevant cable accessory will be used. The Monitor will switch off an automatic welding system in the event that oxygen level should rise above a pre-set limit, thereby preventing the risks of weld oxidation and metallurgical imperfections.”

“The Monitor will switch the welding system back on once the excess oxygen has been purged away. PurgeNet™ also works with PurgeLog™ to easily transfer weld purge data for Quality Control purposes.”

PurgeNet™ controls HFT®’s new PurgeAlarm™. This IP66 Rated (Environmental Protection) Visual Alarm connected to PurgeNet™ displays a red indicator when the oxygen level is reading a greater value than the alarm threshold set by the user.

An optional green indicator can be fitted above the standard red indicator and will illuminate only if the alarm is active and reading a value lower than the alarm threshold set by the user. A sounder is available as an option to provide an audible alarm instead of a light. 

 

Huntingdon Fusion Techniques HFT® have a Worldwide Exclusive Distributor Network.

More information

 


This Press Release is Succesfully Published in Worldwide Magazines, by clicking the logo you can read the article: 

Logo OilVoice  Read the published article directly in the magazine OilVoice - UK and International
Logo GasWorld  Read the published article directly in the magazine GasWorld - UK and International
Logo Scandinavial Oil Gas Magazine  Read the published article directly in the magazine ScandOil - Norway and International
Logo TubeFirst NEW  Read the published article directly in the magazine TubeFirst- UK and International
Logo Wire and Tube News  Read the published article directly in the magazine Wire and Tube News - UK and International
Logo Stainless Steel Americas NEW  Read the published article directly in the magazine Stainless Steel World Americas - USA and International
Logo EngineerLive copy  Read the published article directly in the magazine EngineerLive - UK and International

 


Huntingdon Fusion Techniques HFT® are proud members of:

American Welding Society International Tube Association The Welding Institue Welding World


You are not allowed to use or copy any of this material or content without the written permission of Huntingdon Fusion Techniques HFT®, copyright protected. All rights belong to Huntingdon Fusion Techniques HFT® exclusively. Not for any reproduction without consent.